texas waterjet cutting

Calypso Shark 60,000 PSI Waterjet

Our CNC Waterjet will cut just about any material on the planet!

San Antonio – Houston – Austin

Great for short runs and Prototypes – Custom Foam Packaging

Glass – Stainless -Granite – Marble – Limestone – Steel up to 6 inches thick!

We can cut through almost any material of any thickness, including 4-inch stainless steel. And, unlike laser, EDM or plasma – based processes, our high pressure (50,000 psi) water stream cuts without the thermal distortion which can result in material fatigue or failure. Plus, waterjet cutting leaves a burr-free edge so little or no additional finishing is required. We use a robotically-controlled machine which gives us the freedom to cut configurations in most 3-dimensional composite parts. We can work from your prints, drawings, DXF or IGES files, or we can design a cutting pattern from scratch from your specifications.

  • Cuts any material (except tempered glass)
  • Good for Thicknesses Greater than 3/4″
  • Tile inlays
  • Plastics
  • Glass
  • Rubber
  • Wood (yes wood and beautifully too)
  • All Metals
  • Foam
  • Fiberglass